Beko WML 50821 Washer User Manual


  Open as PDF
of 52
 
4
EN
• Topreventflowingofdirtywaterbackintothe
machine and to allow for easy discharge, do
not immerse the hose end into the dirty water or
driveitinthedrainmorethan15cm.Ifitistoo
long, cut it short.
• Theendofthehoseshouldnotbebent,it
should not be stepped on and the hose must
not be pinched between the drain and the
machine.
• Ifthelengthofthehoseistooshort,useitby
adding an original extension hose. Length of the
hose may not be longer than 3.2 m. To avoid
water leak failures, the connection between
the extension hose and the drain hose of the
product must be fitted well with an appropriate
clamp as not to come off and leak.
Adjusting the feet
A
 Inordertoensurethattheproductoperates
moresilentandvibration-free,itmuststandlevel
and balanced on its feet. Balance the machine
byadjustingthefeet.Otherwise,theproduct
may move from its place and cause crushing
and vibration problems.
1. Loosen the lock nuts on the feet by hand.
2. Adjust the feet until the product stands level and
balanced.
3. Tighten all lock nuts again by hand.
A
 Donotuseanytoolstoloosenthelocknuts.
Otherwise,theywillgetdamaged.
Electrical connection
Connect the product to a grounded outlet protected
by a fuse complying with the values in the "Technical
specifications"table.Ourcompanyshallnotbeliable
for any damages that will arise when the product is
used without grounding in accordance with the local
regulations.
• Connectionmustcomplywithnational
regulations.
• Powercableplugmustbewithineasyreach
after installation.
• Thevoltageandallowedfuseorbreaker
protection are specified in the “Technical
specifications”section.Ifthecurrentvalueof
the fuse or breaker in the house is less than 16
Amps,haveaqualifiedelectricianinstalla16
Amp fuse.
• Thespecifiedvoltagemustbeequaltoyour
mains voltage.
• Donotmakeconnectionsviaextensioncables
ormulti-plugs.
B
 Damagedpowercablesmustbereplacedby
the Authorized Service Agents.
First use
Before starting to use the product, make sure that
all preparations are made in accordance with the
instructionsinsections"Importantsafetyinstructions"
and"Installation".
To prepare the product for washing laundry, perform
firstoperationinDrumCleaningprogramme.If
yourmachineisnotfeaturedwithDrumCleaning
programme,useCottons-90programmeandselect
Additional Water or Extra Rinse auxiliary functions
as well. Before starting the programme, put max.
100gofpowderanti-limescaleintothemainwash
detergentcompartment(compartmentnr.II).Ifthe
anti-limescaleisintabletform,putonlyonetabletinto
compartmentnr.II.Drytheinsideofthebellowwitha
clean piece of cloth after the programme has come
to an end.
C
Useananti-limescalesuitableforthewashing
machines.
C
Some water might have remained in the product
duetothequalitycontrolprocessesinthe
production.Itisnotharmfulfortheproduct.
Disposing of packaging material
Packaging materials are dangerous to children. Keep
packaging materials in a safe place away from reach
of the children.
Packaging materials of the product are manufactured
fromrecyclablematerials.Disposeofthemproperly
and sort in accordance with recycled waste
instructions.Donotdisposeofthemwithnormal
domestic waste.
Transportation of the product
Unplugtheproductbeforetransportingit.Remove
waterdrainandwatersupplyconnections.Drain
the remaining water in the product completely; see,
"Drainingremainingwaterandcleaningthepump
filter".Installtransportationsafetyboltsinthereverse
 previous next