Beko WME 7247 W Washer User Manual


 
EN
10
Connecting to the water
supply.
Important:
• Thewatersupplypressurerequired
to run the machine must be 1-10
bar(0,1–1MPa).(Practically,itis
necessarytohave10–80liters
of water flowing from the tap in
one minute to have your machine
runsmoothly.)Attachapressure-
reducing valve if the water pressure
is higher.
• Connectthespecialhosesupplied
with the machine to the water intake
valves on the machine.
• Inordertopreventwaterleakage
that may occur at the connection
points,therearerubberseals(4
seals for the models with double
water inlet and 2 seals for other
models)attachedtothehoses.
These seals should be used at the
tap and machine connection ends of
the hoses. The plain end of the hose
fitted with a filter must be attached
to the tap and the elbowed end
must be attached to the machine.
Tighten the nuts of the hose well by
hand;neverusewrenchestotighten
the nuts.
• Openthetapscompletelyafter
making the hose connection to
check if there is any water leakage
at the connection points. Turn off
the tap and remove the nut in case
of any leakage. Retighten the nut
carefully after checking the seal.
To prevent any water leakage and
any other damage to be caused by
it, keep the taps closed when the
machine is not in use.
• Modelswithasinglewaterinlet
should not be connected to the
hot water tap. Laundry may be
damaged or the appliance may
switch to protection mode and not
work.
When returning the appliance to its
place after maintenance or cleaning,
care should be taken not to fold,
squeeze or block the hoses.
Connecting to the drain
The water discharge hose can be
attached to the edge of a washbasin
or waste water system. The drain hose
should be firmly fitted into the drain as
to not loosen in its housing.
Important:
• Theendofthedrainhosecan
be directly connected to the
wastewater drain or to the
washbasin. The fitting must be
secured in all types of connections.
Yourhousemaybefloodedifthe
hose falls out of its housing during
water discharging.
• Thehoseshouldbeattachedtoa
height of at least 40 cm, and 100
cm at most.