Filter
Top Products
12 / 42 EN
Washing Machine /User’s Manual
Installation
3.7 Electrical connection
Connect the product to a grounded outlet
protected by a 13 A fuse. Our company shall not
be liable for any damages that will arise when the
product is used without grounding in accordance
with the local regulations.
•Connectionmustcomplywithnational
regulations.
•Powercableplugmustbewithineasyreach
after installation.
•Ifthecurrentvalueofthefuseorbreakerinthe
house is less than 13 Amps, have a qualified
electrician install a 13 Amp fuse.
•Thevoltagespecifiedinthe"Technical
specifications" section must be equal to your
mains voltage.
•Donotmakeconnectionsviaextensioncables
or multi-plugs.
B
WARNING: Damaged power cables
must be replaced by the Authorized
Service Agents.
Electrical requirements
Before you insert the plug into the wall socket
make sure that the voltage and the frequency
shown in the rating label corresponds to your
electricity supply.
We recommend that this appliance be connected
to the mains supply via a suitable switched and
fused socket in a readily accessible position.
Should the mains lead of the appliance become
damaged or need replacing at any time, it must be
replaced by a special purpose made mains lead
which can only be obtained from a Authorised
Service Agent.
B
WARNING: This appliance must be
earthed
If the fitted moulded plug is not suitable for your
socket, then the plug should be cut off and an
appropriate plug fitted.
Destroy the old plug, which is cut off as a plug
with a bared cord could cause a shock hazard if
inserted into a socket elsewhere in the house.
The moulded plug on this appliance incorporates a
13A fuse. Should the fuse need to be replaced an
ASTA approved BS1362 fuse of the same rating
must be used. Do not forget to refit the fuse cover.
In the event of losing the fuse cover, the plug must
not be used until a replacement fuse cover has
been fitted. Colour of the replacement fuse cover
must be the same colour as that visible on the pin
face of the plug. Fuse covers are available from
any good electrical store.
Important
Fitting a different plug
As the colours of the wires in the mains lead
of this appliance may not correspond with the
coloured markings identifying the terminals on
your plug, proceed as follows:
1 Connect the green - yellow or green (earth) wire
to the terminal in the plug marked ‘E’ or with
the symbol f or coloured green and yellow or
green.
2 Connect the blue (neutral) wire to the terminal
in the plug marked ‘N’ or coloured black.
3 Connect the brown (live) wire to the terminal in
the plug marked ‘L’ or coloured red.
With the alternative plugs a 13A fuse must be fitted
either in the plug or adaptor or in the main fuse box. If
in doubt contact a qualified electrician.