Beko WMB 81041 LS Washer/Dryer User Manual


  Open as PDF
of 52
 
14
EN
at which the programme was cancelled remains lit.
"END" appears on the display and the programme
is cancelled.
C
Ifyouwanttoopentheloadingdoorafter
youhavecancelledtheprogrammebutit
isnotpossibletoopentheloadingdoor
sincethewaterlevelinthemachineisabove
the loading door opening, then turn the
ProgrammeSelectionknobtoPump+Spin
programme and discharge the water in the
machine.
Machine is in Rinse Hold mode
SpinsymbolflashesandPausesymbolilluminates
whenthemachineisinRinseHoldmode.
Ifyouwanttospinyourlaundrywhenthemachine
is in this mode:
AdjustthespinspeedandpressStart/Pause
/Cancelbutton.Pausesymboldisappearsand
Startsymbolappears.Programmeresumes,
discharges the water and spins the laundry.
Ifyouonlywanttodrainthewaterwithout
spinning:
JustpressStart/Pause/Cancelbutton.Pause
symboldisappears.Startsymbolappears.
Programme resumes and discharges the water
only.
End of programme
“End” appears on the display at the end of the
programme.Symbolsoftheprogrammesteps
remain lit. Auxiliary function, spin speed and
temperaturethatwereselectedatthebeginningof
the programme remain selected.
avoid touching of the residues in the drawer with
yourskinwhencleaning.Insertthedrawerback
into its place after cleaning and make sure that it is
seated well.
Cleaning the water intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at the
end of each water intake hose where they are
connected to the tap. These filters prevent foreign
substancesanddirtinthewatertoenterthe
washingmachine.Filtersshouldbecleanedas
they do get dirty.
Close the taps. Remove the nuts of the water
intake hoses to access the filters on the water
intake valves. Clean them with an appropriate
brush.Ifthefiltersaretoodirty,takethemout
bymeansofpliersandcleanthem.Takeoutthe
filters on the flat ends of the water intake hoses
together with the gaskets and clean thoroughly
under running water. Replace the gaskets and
filters carefully in their places and tighten the hose
nutsbyhand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
itemssuchasbuttons,coinsandfabricfibers
clogging the pump impeller during discharge of
washingwater.Thus,thewaterwillbedischarged
withoutanyproblemandtheservicelifeofthe
pump will extend.
Ifthemachinefailstodrainwater,thepumpfilter
isclogged.Filtermustbecleanedwheneverit
iscloggedorinevery3months.Watermustbe
drained off first to clean the pump filter.
Inaddition,priortotransportingthemachine
(eg., when moving to another house) and in case
offreezingofthewater,watermayhavetobe
drained completely.
A
 Foreignsubstancesleftinthepumpfiltermay
damage your machine or may cause noise
problem.
Inordertocleanthedirtyfilteranddischargethe
water:
Unplugthemachinetocutoffthesupplypower.
A
Temperature of the water inside the machine
mayriseupto90ºC.Toavoidburningrisk,
filtermustbecleanedafterthewaterinthe
machine cools down.
Openthefiltercap.
5 Maintenance and cleaning
Servicelifeoftheproductextendsandfrequently
facedproblemsdecreaseifcleanedatregular
intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
(every4-5washingcycles)asshownbelow
in order to prevent accumulation of powder
detergent in time.
Press the dotted point on the siphon in the
softener compartment and pull towards you until
the compartment is removed from the machine.
C
Ifmorethannormalamountofwaterand
softener mixture starts to gather in the
softenercompartment,thesiphonmustbe
cleaned.
Wash the detergent drawer and the siphon with
plentyoflukewarmwaterinawashbasin.Wear
protectiveglovesoruseanappropriatebrushto
 previous next