Beko WMB 61021 M Washer User Manual


  Open as PDF
of 64
 
13
EN
Your machine will end the programme when you
turntheProgrammeSelectionknob;however,
it does not drain the water inside. When you
select and start a new programme, the newly
selected programme will start depending on the
step the previous programme was canceled in.
For example, it may take in additional water or
continue to wash with the water inside.
C
Dependingonthestepwherethe
programme was canceled in, you may have
to put detergent and softener again for the
programme you have selected anew.
5 Maintenance and cleaning
Servicelifeoftheproductextendsandfrequently
facedproblemsdecreaseifcleanedatregular
intervals.
Cleaning the detergent drawer
Clean the detergent drawer at regular intervals
(every4-5washingcycles)asshownbelow
in order to prevent accumulation of powder
detergent in time.
Press the dotted point on the siphon in the
softener compartment and pull towards you until
the compartment is removed from the machine.
C
Ifmorethannormalamountofwaterand
softener mixture starts to gather in the
softenercompartment,thesiphonmustbe
cleaned.
Wash the detergent drawer and the siphon with
plentyoflukewarmwaterinawashbasin.Wear
protectiveglovesoruseanappropriatebrushto
avoid touching of the residues in the drawer with
yourskinwhencleaning.Insertthedrawerback
into its place after cleaning and make sure that it
is seated well.
Cleaning the water intake filters
There is a filter at the end of each water intake
valve at the rear of the machine and also at
the end of each water intake hose where they
are connected to the tap. These filters prevent
foreignsubstancesanddirtinthewatertoenter
thewashingmachine.Filtersshouldbecleaned
as they do get dirty.
Close the taps. Remove the nuts of the water
intake hoses to access the filters on the water
intake valves. Clean them with an appropriate
brush.Ifthefiltersaretoodirty,takethemout
bymeansofpliersandcleanthem.Takeoutthe
filters on the flat ends of the water intake hoses
together with the gaskets and clean thoroughly
under running water. Replace the gaskets and
filters carefully in their places and tighten the hose
nutsbyhand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
itemssuchasbuttons,coinsandfabricfibers
clogging the pump impeller during discharge
ofwashingwater.Thus,thewaterwillbe
dischargedwithoutanyproblemandtheservice
life of the pump will extend.
Ifthemachinefailstodrainwater,thepumpfilter
isclogged.Filtermustbecleanedwheneverit
iscloggedorinevery3months.Watermustbe
drained off first to clean the pump filter.
Inaddition,priortotransportingthemachine
(eg., when moving to another house) and in case
offreezingofthewater,watermayhavetobe
drained completely.
A
 Foreignsubstancesleftinthepumpfilter
may damage your machine or may cause
noiseproblem.
Inordertocleanthedirtyfilteranddischargethe
water:
Unplugthemachinetocutoffthesupplypower.
A
Temperature of the water inside the machine
mayriseupto90ºC.Toavoidburningrisk,
filtermustbecleanedafterthewaterinthe
machine cools down.
Openthefiltercap.
Ifthefiltercapiscomposedoftwopieces,
pressthetabonthefiltercapdownwards
and pull the piece out towards yourself.
Ifthefiltercapisonepiece,pullthecapfrom
bothsidesatthetoptoopen.
 previous next