Beko WMB71642W Washer User Manual


 
Too much foam forms in the machine.
Improper detergents for the washing machine are being used. >>> Use detergents
appropriate for the washing machine.
Excessive amount of detergent is used. >>> Use only sufficient amount of detergent.
Detergent was stored under improper conditions. >>> Store detergent in a closed and
dry location. Do not store in excessively hot places.
Some meshed laundry such as tulle may foam too much because of their texture. >>>
Use smaller amounts of detergent for this type of item.
Detergent is put in the wrong compartment. >>> Put the detergent in the correct
compartment.
Softener is being taken early. >>> There may be problem in the valves or in the
detergent dispenser. Call the Authorized Service Agent.
Regular drum cleaning is not applied. >>> Clean the drum regularly. For this, please
see "Cleaning the loading door and the drum".
Foam is overflowing from the detergent drawer.
Too much detergent is used. >>> Mix 1 tablespoonful softener and ½ l water and pour
into the main wash compartment of the detergent drawer.
C
Put detergent into the machine suitable for the programmes and maximum loads
indicated in the “Programme and consumption table”. When you use additional
chemicals (stain removers, bleaches and etc), reduce the amount of detergent.
Laundry remains wet at the end of the programme
Excessive foam might have occurred and automatic foam absorption system might
have been activated due to too much detergent usage. >>> Use recommended
amount of detergent.
C
Machine does not switch to spinning step when the laundry is not evenly distributed in
the drum to prevent any damage to the machine and to its surrounding environment.
Laundry should be rearranged and re-spun.
A
If you cannot eliminate the problem although you follow the instructions in this section,
consult your dealer or the Authorized Service Agent. Never try to repair a nonfunctional
product yourself.
Machine does not start. Nothing appears on the display.
Machine may be unplugged. >>> Check the plug and attach it to the socket.
Fuse may be defective. >>> Check the fuse and have it replaced by a qualified electrician if
necessary.
Power may be out. >>> Check if there is any power outage.
On / Off button might not be pressed. >>> Press On / Off button.
Machine does not start when Start / Pause / Cancel button is pressed after selecting the
programme.
Loading door may be open. >>> Close the loading door.
Rinse symbol flashes in the display. (No Water symbol may also be lit depending on the
model of your machine).
Water may be cut off. >>> Make sure that the water is not cut off and press Start / Pause /
Cancel button again to start your machine.