Beko WMA 647 W Washer User Manual


  Open as PDF
of 36
 
EN
26
Detergent drawer
Remove any powder residue buildup in
thedrawer.Todothis;
1. Pressthedottedpointonthe
siphon in the softener compartment
and pull towards you until the
compartment is removed from the
machine.
C
If more than a normal amount of
water and softener mixture starts to
gather in the softener compartment,
the siphon must be cleaned.
2. Wash the dispenser drawer
and the siphon with plenty of
lukewarm water in a washbasin.
Wear protective gloves or use an
appropriate brush to avoid touching
the residues in the drawer when
cleaning.
3. Replace the drawer into its housing
after cleaning. Check if the siphon
is in its original location.
The door and the drum
Aftereachwash:
• Checkifthereareanyforeign
substances in the drum.
• Opentheholeinthebellowwiththe
aid of a toothpick if it is clogged.
C
Foreign metal substances in your
machine can cause rust stains. In
suchcases:
Clean the drum with a stainless steel
cleaning agent. Never use steel wool
or wire wool.
Outer cabinet and control
panel
Whennecessary:
• Wipetheexteriorpanelsofyour
machine with soapy water or mild
detergent. Dry it with a soft cloth.
• Useonlyasoftanddampclothto
clean the control panel.
C
Never use a sponge or scrubbing
material. These will damage the
painted and plastic parts.
Inlet water filters
There is a filter at the end of each
water intake valve at the back side of
the machine and also at the end of
each water intake hose where they
are connected to the tap. These filters
prevent the foreign substances and dirt
in the water to enter into the machine.
Filters should be cleaned as they get
dirty.
• Closethetaps.
• Removethenutsofthewaterintake
hoses to clean the surfaces of the
filters on the water intake valves with
an appropriate brush.
7 Cleaning and care
 previous next