Filter
Top Products
26
EN
5. Make changes in auxiliary functions,
temperature and speed settings if
necessary.
6. Press Start / Pause / Cancel button
to start the machine.
C
The loading door will not open if the
water temperature in the machine is
high or the water level is above the
door opening.
Child Lock
Use Child Lock function to prevent
children from tampering with the
machine. Thus you can avoid any
changes in a running programme.
C
You can switch on and off the
machine with On / Off button when
the Child Lock is active. When
you switch on the machine again,
programme will resume from where
it has stopped.
To activate the Child Lock:
Press and hold 2
nd
and 4
th
Auxiliary
Function buttons for 3 seconds. “Con”
appears on the display.
C
Same phrase will appear on the
display if you press any button when
Child Lock is enabled.
To deactivate the Child Lock:
Press and hold 2
nd
and 4
th
Auxiliary
Function buttons for 3 seconds. “COFF”
appears on the display.
C
Do not forget to disable the child
lock at the end of the programme
if it was enabled before. Otherwise,
machine will not allow to select a
new programme.
Cancelling the programme
Press and hold Start / Pause / Cancel
button for 3 seconds. Start symbol
flashes. Symbol of the step at which
the programme was cancelled remains
lit. "End" appears on the display and the
programme is cancelled.
C
If you want to open the loading
door after you have cancelled the
programme but it is not possible
to open the loading door since the
water level in the machine is above
the loading door opening, then turn
the Programme Selection knob
to Pump+Spin programme and
discharge the water in the machine.
Machine is in Rinse Hold mode
Spin symbol flashes and Pause symbol
illuminates when the machine is in Rinse
Hold mode.
If you want to spin your laundry when
the machine is in this mode:
Adjust the spin speed and press Start /
Pause / Cancel button. Pause symbol
disappears and Start symbol appears.
Programme resumes, discharges the
water and spins the laundry.
If you only want to drain the water
without spinning:
Just press Start / Pause / Cancel
button. Pause symbol disappears. Start
symbol appears. Programme resumes
and discharges the water only.
End of programme
“End” appears on the display at the
end of the programme. Symbols of the
programme steps remain lit. Auxiliary
function, spin speed and temperature
that were selected at the beginning of
the programme remain selected.