Filter
Top Products
27
EN
Ending the program
through cancelling
“Start/Pause/Cancel” button is
pressed for 3 seconds to cancel the
program. Start symbol will flash during
cancellation. After cancellation, the
symbol of the corresponding step at
which the cancellation was made will
remain lit and “End” will appear on the
screen.
Program in rinse hold mode
•
This process is shown with the
flashing Spin Symbol and the lit up
Standby Symbol.
If you wish to spin when the machine is
in this mode:
Adjust the spin speed. Press “Start/
Pause/Cancel” button. The program
continues, pumps out the water and
spins. The Standby Symbol fades out
and Start Symbol lights up.
If you want to discharge the water only
without spinning:
Press “Start/Pause/Cancel” button.
The Standby symbol will fade. The
Start symbol will light up. The program
continues and only drains the water.
End of program
When the program is finished, the
symbols of the relevant steps will remain
lit up and the auxiliary function, spin and
temperature data selected at the start-
up of the program will remain selected.
“End” will appear on the display.