Beko WCB 77087 Washer/Dryer User Manual


 
8 - EN
Auxiliary functions
Auxiliary function selection keys
Select the required auxiliary functions before
starting the program.
Auxiliary
function
buttons may differ
according to the model of your machine.
Auxiliary function selection
If an auxiliary function that should not be
selected together with a previously selected
function is chosen, the first selected function
will be cancelled and the last auxiliary function
selection will remain active.
For example: If you want to select pre-wash
first and then quick wash, pre-wash will be
cancelled and quick wash will remain active.
Auxiliary function that is not compatible
with the program cannot be selected. (see
“Program Selection Table”)
• Prewash
A pre-wash is only worthwhile for heavily
soiled laundry. Without pre-wash you save
energy, water, detergent and time. Pre-wash
without detergent is recommended for lace
and curtains.
Quick wash
Anti-creasing
• No Spin
You may use this program if you do not want
to spin your clothes at the end of cottons,
synthetics, woolen or delicate programs.
• Spin speed reduction
You may use the speed reduction button
whenever you wish to spin your clothes
below the maximum spin speed. When speed
reduction button is pressed, spin speed will be
at the minimum rpm given on the panel.
• Pet hair removal
This function helps you to remove the pet hairs
that remain on your clothes.
When this function is selected, your machine
adds pre-wash and additional rinsing steps to
the normal program cycle. Thus, pet hairs are
removed more effectively by performing the
washing with more water
(30%).
Never wash your pets in your washing
machine.
Starting the Program
Press “Start/Pause/Cancel” button to start
the program. “Start/Pause/Cancel” button
will light up to indicate that the program has
started. The door is locked and the “Lid” light
fades.
Progressing a program
Progress of a running program is shown
through the program follow-up indicator. At the
beginning of every program step, the relevant
indicator lamp will light up and light of the
completed step will turn off.
If the machine is not spinning,
the
program may be in rinse hold mode or the
automatic spin correction system has been
activated because of excessive unbalanced
distribution of laundry in the machine.
Changing the selections after the
program has started
You can use this feature after your machine
has started to wash different textile groups
in the same batch of clothes under higher
or lower temperatures. You must cancel the
ongoing program in order to change the
washing program.
For example, press and hold the “Start/Pause/
Cancel” button for 3 seconds to “Cancel”
the program in order to select “Cottons 40”
program instead of “Cottons 60” program.
Select the “Cottons 40” program by rotating
the program knob. Press “Start/Pause/Cancel”
button to start the program.
Switching the machine to standby
mode
Press “Start/Pause/Cancel” button
momentarily to switch your machine to the
standby mode. Auxiliary functions can be
Use this function for smaller
amounts or slightly soiled laundries.
Use this function for delicate
laundries that crease easily.
Whenever you select this auxiliary
function, load your machine with
half of the maximum laundry amount
specified in the program table.