Beko EV 6800 Washer User Manual


  Open as PDF
of 26
 
10 - EN
programme,useCotton-90programme.Before
starting the programme, put max. 100 g of powder
anti-limescale into the main wash detergent
compartment(compartmentnr.II).Iftheanti-
limescaleisintabletform,putonlyonetabletinto
compartmentnr.II.Drytheinsideofthebellowwith
a clean piece of cloth after the programme has
come to an end.
C
 RepeatDrumCleaningprocessinevery2
months.
C
 Useananti-limescalesuitableforthewashing
machines.
After every washing make sure that no foreign
substanceisleftinthedrum.
Iftheholesonthebellowshowninthefigureis
blocked,opentheholesusingatoothpick.
C
 Foreignmetalsubstanceswillcauseruststains
in the drum. Clean the stains on the drum
surfacebyusingcleaningagentsforstainless
steel. Never use steel wool or wire wool.
Cleaning the body and control panel
Wipethebodyofthemachinewithsoapywater
or non-corrosive mild gel detergents as necessary,
and dry with a soft cloth.
Useonlyasoftanddampclothtocleanthecontrol
panel.
A
Neverusespongeorscrubmaterials.These
will damage the painted and plastic surfaces.
Cleaning the water intake filters
There is a filter at the end of each water intake valve
at the rear of the machine and also at the end of
each water intake hose where they are connected
tothetap.Thesefilterspreventforeignsubstances
and dirt in the water to enter the washing machine.
Filtersshouldbecleanedastheydogetdirty.
Close the taps. Remove the nuts of the water intake
hoses to access the filters on the water intake
valves.Cleanthemwithanappropriatebrush.Ifthe
filtersaretoodirty,takethemoutbymeansofpliers
and clean them. Take out the filters on the flat ends
of the water intake hoses together with the gaskets
and clean thoroughly under running water. Replace
the gaskets and filters carefully in their places and
tightenthehosenutsbyhand.
Draining remaining water and
cleaning the pump filter
The filter system in your machine prevents solid
itemssuchasbuttons,coinsandfabricfibers
clogging the pump impeller during discharge of
washingwater.Thus,thewaterwillbedischarged
withoutanyproblemandtheservicelifeofthe
pump will extend.
Ifthemachinefailstodrainwater,thepumpfilter
isclogged.Filtermustbecleanedwheneverit
iscloggedorinevery3months.Watermustbe
drained off first to clean the pump filter.
Inaddition,priortotransportingthemachine(e.g.,
when moving to another house) and in case of
freezingofthewater,watermayhavetobedrained
completely.
A
Foreignsubstancesleftinthepumpfiltermay
damage your machine or may cause noise
problem.
Inordertocleanthedirtyfilteranddischargethe
water:
Unplugthemachinetocutoffthesupplypower.
A
Temperature of the water inside the machine
mayriseupto90ºC.Toavoidburningrisk,filter
mustbecleanedafterthewaterinthemachine
cools down.
Openthefiltercoverbypullingitfrombothsidesat
the top.
C
 Youcanremovethefiltercoverbyslightly
pushing downwards with a thin plastic tipped
tool,throughthegapabovethefiltercover.Do
not use metal tipped tools to remove the cover.
Followthestepsbelowtodischargethewater.
Place a large container in front of the filter to
catch water from the filter. Loosen pump filter
(anticlockwise) until water starts to flow. Fill the
flowing water into the container you have placed
in front of the filter. Always keep a piece of cloth
handytoabsorbanyspilledwater.Whenthewater
inside the machine is finished, take out the filter
completelybyturningit.
Cleananyresiduesinsidethefilteraswellasfibers,
ifany,aroundthepumpimpellerregion.Installthe
filter.
Seatthetabsinthelowerpartintotheirplacesfirst,
and then press the upper part to close.
 previous next