Filter
Top Products
19
EN
Changing the programme after
it has started
You can use this feature to dry
your clothes under higher or lower
temperatures after your dryer has started.
For example;
1. Press and hold the “Start/Pause/
Cancel” button for about 3 seconds
to “Cancel” the programme in order to
select “Extra Dry” programme instead
of “Iron Dry” programme.
2. Select the “Extra Dry” programme
by rotating the programme selection
button.
3. Press “Start/Pause/Cancel” button to
start the programme.
C Press “Start/Pause/Cancel” button for
3 seconds to cancel the programme
or turn the programme selection knob
in any direction to end the programme
while the machine is running. Water
tank and filter cleaning warning lights
turn on to warn the user when the
programme is cancelled by pressing
the “Start/Pause/Cancel” button for 3
seconds. However, the warning lights
do not turn on when the programme
is cancelled by turning the programme
selection knob. Only the drying light
turns on and the machine remains in
hold until a new programme is selected
and the “Start/Pause/Cancel” button
is pressed. Child-proof lock of the
machine should not be active in order
to perform these two operations. If the
child-proof lock is active, deactivate it
before performing these operations.
Adding/removing laundry in
standby mode
In order to add or remove laundry after
the programme starts:
1. Press the “Start/Pause/Cancel” button
to switch the dryer to “Pause” mode.
Drying process will stop.
2. Open the door at “Pause” position and
close it again after adding or taking out
laundry.
3. Press “Start/Pause/Cancel” button to
start the programme.
C Any laundry added after the drying
process has started may cause
the dried clothes in the machine
intermingle with wet clothes and the
result will be wet laundry after the
drying process is over.
C Laundry may be added or taken out
as much as desired during a drying
process, but this process will extend
the programme duration and increase
energy consumption since the drying
will be interrupted continuously.
Therefore, it is recommended to add
laundry before the drying programme
has started.
Child-proof lock
There is a child-proof lock to prevent
any programme interruption due to the
pressing of button while the programme
is running. The loading door and all
buttons except the “On/Off” button on
the control panel are deactivated when
the child-proof lock is active.
Press the “Start/Pause/Cancel” and
“Cancel audio warning” buttons
simultaneously for 3 seconds to activate
the child-press lock.
To start a new programme after the
programme is over or to interrupt the
programme, the child-proof lock should
be deactivated. Press the same buttons
for 3 sec. again to deactivate the child-
proof lock.
C Child-proof lock is deactivated when
the machine is restarted by pressing
the On/Off button.
CPress the relevant buttons for 3
seconds to activate the child-proof
lock. A long beep will be heard and
the child-proof lock will be activated. A
double beep will be heard if you press
any button or turn the programme
selection knob while the child-proof
lock is active. Press the buttons for 3
seconds to deactivate the child-proof
lock. Single beep will be heard and
child-proof lock will be deactivated.
A A double beep will be heard if you turn
the programme selection knob when