Filter
Top Products
28
EN
There are dampness sensors in the
machine that detect whether the laundry
is dry or not.
To clean the sensors:
1. Open the loading door of the
machine.
2. Allow the machine to cool down if it is
still hot due to the drying process.
3. Wipe the metal surfaces of the sensor
with a soft cloth, dampened with
vinegar and dry them.
C
Clean metal surfaces of the sensors 4
times a year.
C
Do not use metal tools when cleaning
metal surfaces of the sensors.
A
Never use solvents, cleaning agents
or similar substances for cleaning due
to the risk of fire and explosion!
Draining the water tank
Dampness of the laundry is removed and
condensed during drying process and the
water formed accumulates in the water
tank. Drain the water tank after each
drying cycle.
A
Condensed water is not drinkable!
A
Never remove the water tank when
the programme is running!
If you forget to drain the water tank, the
machine will stop during the subsequent
drying cycles when the water tank is full
and the Water Tank warning symbol will
flash. If this is the case, drain the water
tank and press Start / Pause / Cancel
button to resume the drying cycle.
To drain the water tank:
1. Pull the drawer and remove the water
tank carefully.
2. Drain the water in the tank.
3. If there is lint accumulation in the
funnel of the water tank, clean it
under running water.
4. Place the water tank into its seat.
Cleaning the filter drawer
Lint and fibre that could not be captured
by the lint filter are blocked in the filter
drawer behind the kick plate. Filter
Drawer Cleaning warning light will light up
maximum at every 5 drying cycles as a
reminder.
There is a two-level filter in the filter
drawer. The first level is the filter drawer
sponge and the second level is the filter
cloth.
To clean the filter drawer:
1. Press the kick plate button to open
the kick plate.