Beko D1 5102 BS Washer User Manual


 
EN
21
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Place the laundry in the machine.
3. Add detergent and softener.
Starting
1. Press the “On/Off” button.
2. Select the programme and the
temperature.
3. If required (according to your
machine’s model):
select any auxiliary function,
adjust the spin speed,
set the time delay,
4. Close the loading door.
5. Press Start/Pause/Cancel button.
Canceling a program
Press “Start/Pause/Cancel” button
for 3 seconds. The machine starts
to discharge the water. “Wash” and
“Program Finished” lights will light
up.
"Start/Pause/Cancel" and “Wash”
lights will go off after discharging
process is over and the “Lid” light
will start flashing.
If the program is cancelled in the
middle of the process, “Wash”
and “Program Finished” lights will
light up. The machine can drain
all the water or can take in water
for 3 times at most to cool down
the clothes and complete draining
process. When water discharging
process is completed, “Wash” light
will go off, “Program Finished” light
will light up and the “Lid” light will
continuously flash until the door
is allowed to be opened. You can
make a new program selection when
the “Lid” light is lit continuously.
Adding more laundry
You may add more laundry into the
machine at the beginning of washing.
C Machine allows adding more laundry
during a later step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low enough.
In order to add laundry after the start-up
of the program:
1. Press Start/Pause/Cancel button.
Wait until the door is allowed
to open. “Lid” lamp will light up
continuously when the door is
allowed to open.
2. Open the loading door and put in
more laundry.
3. Close the loading door.
4. Press Start/Pause/Cancel button.
Program is in rinse hold mode
C After the machine fills with water in
the final rinse step, clothes can be
soaked in the machine as long as
desired.
When it reaches this position while the
machine is running, the “Start/Pause/
Cancel” light will flash.
In the machines equipped with spin
speed selection knob, you can spin by
selecting the desired spin speed and
press "Start/Pause/Cancel" button.
As for machines not equipped with a
spin speed selection knob, you can
end the program without spinning by
pressing the “Start/Pause/Cancel”
button to drain the water. You may spin
your clothes whenever you wish to by
selecting the spin program.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
If you want to re-spin the clothes:
1. Rearrange the previously placed
clothes in machine.
2. Select Spin+Pump program.
6 Quick instructions for daily use