Beko 2012 CXY Washer/Dryer User Manual


  Open as PDF
of 31
 
EN
27
The door is jammed.
- Water level might be above the lower
level of the door.
-Machinemightbeheatingupthewater
or it may be at the spinning cycle.
- Due to an electrical mechanism, the door
can only be opened a few minutes after
theProgrammehasstopped.
-Runeitherthe“Pump”or“Spin”Programme.
- Wait until the process is over.
- Wait until the process is over.
Machinefillswithwaterwhenaprocessiscancelled.
Inside of machine may be hot.
For safety reasons cold water is added to cool
the hot wash load
Itcontinuouslyspins.Remainingtimedoesnotcountdown.(Onmodelswithdisplay)
There may be an imbalance of laundry in
the machine.
- The automatic spin correction system might
have been activated due to the unbalanced
distribution of the laundry in the drum.
- The laundry in the drum may be clustered
(bundledlaundryinabag).Laundryshouldbe
rearranged and re-spun.
- No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
Washing time takes longer than the time specified in the manual
- Water pressure may be low.
- Supply voltage may be low.
- Input temperature of water may be low.
- There may be an imbalance of laundry in
the machine.
- Number of rinses and/or amount of rinse
water might have increased.
- The machine will wait until there is sufficient
amount of water, which will lengthen the
washing time to avoid poor washing results due
to insufficient water.
- Washing time is extended to avoid poor
washing results when the supply voltage is low.
- Cycle time is extended to heat up the water
when the input water is cold. Also, washing
time can be lengthened to avoid poor washing
results.
- The automatic spin correction system might
have been activated due to the unbalanced
distribution of the laundry in the drum.
- The laundry in the drum may be clustered
(bundledlaundryinabag).
- Laundry should be rearranged and re-spun.
- No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
- Water amount is increased to obtain a
better rinse and a rinse cycle is added when
necessary.
 previous next