Beko 15085 Washer/Dryer User Manual


  Open as PDF
of 32
 
EN
27
The door is jammed.
- Water level might be above the lower
level of the door.
-Machinemightbeheatingupthe
water or it may be at the spinning
cycle.
- Due to an electrical mechanism,
the door can only be opened a few
minutes after the programme has
stopped.
-Runeitherthe“Pump”or“Spin”programme.
- Wait until the process is over.
- Wait until the process is over.
Machinefillswithwaterwhenaprocessiscancelled.
Inside of machine may be hot.
For safety reasons, water should be cycled in and
out a couple times.
Itcontinuouslyspins.Remainingtimedoesnotcountdown.(Onmodelswithdisplay)
There may be an imbalance of laundry
in the machine.
- The automatic spin correction system might have
been activated due to the unbalanced distribution
of the laundry in the drum.
- The laundry in the drum may be clustered
(bundledlaundryinabag).Laundryshouldbe
rearranged and re-spun.
- No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
Washing time takes longer than the time specified in the manual
- Water pressure may be low.
- Supply voltage may be low.
- Input temperature of water may be
low.
- There may be an imbalance of
laundry in the machine.
- Number of rinses and/or amount of
rinse water might have increased.
- The machine will wait until there is sufficient
amount of water, which will lengthen the washing
time to avoid poor washing results due to
insufficient water.
- Washing time is extended to avoid poor washing
results when the supply voltage is low.
- Cycle time is extended to heat up the water when
the input water is cold. Also, washing time can be
lengthened to avoid poor washing results.
- The automatic spin correction system might have
been activated due to the unbalanced distribution
of the laundry in the drum.
- The laundry in the drum may be clustered
(bundledlaundryinabag).
- Laundry should be rearranged and re-spun.
- No spinning is performed when the laundry is
not evenly distributed in the drum to prevent any
damage to the machine and to its environment.
- Water amount is increased to obtain a better
rinse and a rinse cycle is added when necessary.
 previous next