12
? PREPARATION
1. Connect the water inlet hose
to the water faucet. Don’t
switch on the power if the
water pressure is lower than
0.05MPa and higher than
0.5MPa.
2. Open the water faucet.
3. Insert the plug into the
socket. For safety the plug
should have ground
connection.
4. Place the drain hose in the
correct position.
5. Open the door and put the
wash load into the tub
evenly. Then close the door.
6. Pull out the detergent drawer and add the wash detergent and
softener to the corresponding position as following:
? For pre-wash detergent
? For wash detergent
? For softener
When using the liquid detergent (recommended for programs
without pre-wash process), insert the detergent cup and follow
the instructions on the package.
When using the soap powder, remember to remove the liquid
detergent cup.
NOTE: DO NOT overflow the detergent and softener
compartment.
7. Push back the detergent
drawer.
WARNING: DO NOT pull out the
detergent drawer while the
a
ppliance is in operation because
this may cause water to spill out.
1. Insert the load to be washed into the unit
2. Turn on the unit to your desired mode.
3. Add dete rgent or liquid soap (see page 12 for details).
4. Wait for 3 minutes after the washing cycle starts. Then measure the correct amount of liquid
chlorine bleach (do not exceed 1/3 cup) otherwise you will damage the clothes.
5. Open the drawer and pour the liquid chlorine bleach into center section 2 of drawer
2.
Turn on the water faucet.
?
Warning
?
When using liquid chlorine bleach you must follow these steps.
Failure to follow these directions may result in damaged clothes.