Avanti W797 Washer User Manual


 
14
OPERATION INSTRUCTIONS
PRESS DOWN POWER BUTTON.
PRESS DOWN WATER LEVEL BUTTON.
Choose appropriate water level according to wash load quantity.
WATER TEMPERATURE CHOICE.
Press down the water temperature selection button, you can choose to inlet cold water or hot water.
When the cold-water indicator and the hot-water indicator turn on simultaneously, which means you
chose the warm water.
NOTE: The washer will provide a cold rinse in all TEMPERATURE settings.
IMPORTANT: A single cold hose system does not allow the washing machine to automatically
(select) regulate incoming water temperatures to match those listed on the control panel such as
WARM or HOT.
PRESS DOWN WASH TIME SELECTION BUTTON.
Press down wash time selection button to select the wash time. You can also press the button to
select soak.
NOTE: When all indicators are OFF, the wash cycle is finished.
PRESS DOWN RINSE TIMES SELECT BUTTON.
Press this button to select the times of rinse. When SPRAY RINSE is selected, the washing machine
will spray water to rinse firstly during rinse course.
NOTE: When all indicators are OFF, the rinse cycle is finished.
PRESS DOWN SPI N TIME SELECT BUTTON.
Press this button to select the time of spin.
NOTE: When all indicators are OFF, the spin cycle is finished.
IMPORTANT NOTE: You can select different WASH, RINSE and SPIN combinations according to
your needs.
PRESS DOWN PRESET BUTTON.
Press this button for delay start setting and children-proof setting.
PRESS DOWN FUNCTIONS SELECTION BUTTON.
Choose the desired function and then the corresponding indicator blink.
PRESS DOWN START/HOLD BUTTON ONCE AND THE MACHINE WILL BEGIN OPERATION.
Please press this button to stop the normal operation, if it continues to work, press it again.
Water level can be reset during the normal operation. If the higher water level is selected, the machine
will operate after refilling the water level selected.
AUTOMATIC WASH PROGRAMS
NORMAL For normal laundry
? Press down the power button.
? The NORMAL indicator will be ON. (NORMAL is the default program)
? Press the water supply button to select the water temperature.
? Press the water level button to select the appropriate water level setting. (The default water level
is HIGH)
? Press the START/HOLD to start the course. And the LED display will show the remaining time of
the entire course.