Filter
Top Products
21
GB
Transit packing
After removing the packing, check the appliance for damage.
If you have any doubts do not use the washer and call a
qualified technician. Keep the packaging components (plastic
bags, polyester foam, nails etc.) out of the reach of children
since they could be dangerous. The interior of the washer,
has an oscillating unit which is fixed on the back by 3 screws
during transport (figure 3). Before starting up the washer,
release the unit, by unscrewing the 3 screws. Seal the screw
holes with the plastic plugs supplied with the appliance.
Levelling
The machine must be level in order to operate properly, To
level the machine, simply regulate the adjustable feet (fig. 4);
the angle of inclination (measured on the top of the machine)
must not exceed 2 degrees. If the washer is installed on a
carpeted floor, check that there is sufficient ventilation space
between the floor and the bottom of the machine.
Water supply
Make sure that the water pressure is between the maximum
and minimum values indicated on the data plate located on
the back of the washer. Connect the inlet hose to a cold
water tap with a 3/4 gas threaded opening, and fit the filter
and the rubber gasket supplied with the washer. Check that
it is tightly screwed to the tap (see fig. 5). If the water piping
is new or has not been udes for a long time, before making
the connection, let the water run until it is clear and free
from impurities. This step is necessary to ensure that the
incoming water does not clog and possibly damage the
washer. Connect the other end of the pipe to the appliance,
at the top on the right, by the water connection (see fig. 6).
Installation
A
Fig. 5
Fig. 6
Connecting the drain pipe
Connect the drain hose to a drain (with a minimum inner
diameter of 4 cm), avoiding excessive crimping or the
formation of elbows. It is important that the hose be
positioned at a height greater than 60 cm. If this is not the
case, the hose must be fastened to the hook located on the
top part of the back of the machine (fig. 7).
If a drain pipe coming from the wall is used to connect the
hose, have a qualified plumber/technician check to make
sure that it functions properly. If your home is on the top of
an apartment building or condominium, the drain may be
subject to a siphoning effect which results in the machine
filling and draining continuously. To eliminate this
inconvenience, special valves are available on the market
which can be fitted to the drain hose.
Electrical connection
Before connecting the appliance to the mains, check the
following:
1) your mains socket must support then maximum power
load of the appliance, which is shown on the data plate; in
addition the socket must comply with legal regulations;
2) the supply voltage must correspond to the values shown
on the data plate;
3) the socket must be suitable for the plug of the appliance;
replace the socket or the plug but do not use an adapter;
4) home electrical systems must be earthed, in compliance
with ministerial directives. Should the electric system of your
home not comply with these directives, the manufacturer
declines any liability for any possible consequences.
Fig. 7
Fig. 3
Fig. 4