Filter
Top Products
NA
11
Program and Option Modifiers
Option modifiers
Superwash:
Use this option to select a more intensive wash and time program for the cotton (Sanitary, Heavy cotton, Regular cotton,
Heavy synthetics) and synthetics-permanent press (Heavy synthetics, Regular Synthetics).
Pre-wash Button:
For heavily soiled loads, push this button to adf an extra wash to any wash program
(except the 4-7-10-11 programs).
Easy Iron Button (Rinse Hold):
This option reduces the amount of creasing on fabrics, making them easier to iron.
Selecting this option the washing machine will reduce wash action and spin speed (max 600 rpm) for programs
5-6-7 and the machine will stop on the last rinse.
For the Silk program the Easy iron (stop with water) option is automatically carried out also if the button Easy iron is not
pressed: the washer will pause the cycle in the final rinse with laundry soaked.
The machine will stay in this state until either the Start/Cancel button is pressed or the Easy iron is pressed again to finish the
cycle .
Time Delay up to 24 hours:
Use this option to delay the program start by up to 24 hours. The display will show the delay chosen. Each press of the
button increases the Time delay in increments of 1 hour. If you press the button again after 24 shows in the display the
machine will reset the Time Delay and show OFF in the display, pressing the button after this start the Time Delay selection
from 1 hour. Once the countdown reaches zero the program will start.
Soaking:
This option allows you to leave your washing to soak for one hour during the wash cycle.
During this time your washing machine tumbles every 2 minutes for 6 seconds (excepts 7, 8, 9, 10, 11 programs).
Variable Spin Speed:
Use this option to reduce the spin speed below the maximum for the program you have chosen.
Each press of the button will reduce the spin speed. The new spin speed will be shown in the display.
If you press again after OFF has been displayed, the machine will revert to the original higher spin speed.
N.B.: The washing machine will automatically prevent you from selecting a spin speed higher than the
maximum speed for each program.
Variable Temperature:
Use this option to reduce the wash temperature below the maximum for the program you have chosen.
The allowed selections are: 1: Cold (cold wash/cold rinse)
2: Warm (warm wash/cold rinse)
3: Hot (hot wash/cold rinse)
4: Sanitary
The cycle Sanitary is the one in which the heater element works.
Warning: If you select an option unsuitable to the chosen program the corresponding LED will blink for
some seconds and then will go out.
If the the option selected is suitable to the chosen
program the button LED will stay on.
In the event of an anomaly, an error code will appear, such as F-01, which should be communicated
to the Service Centre (see page 22)