Filter
Top Products
Installation
Description
Start and
Programmes Laundry
Warnings and
Suggestions
Maintenance and
Care Troubleshooting Service
GB
3
replacing the empty water container, the dryer must be
running for this to happen (see The Controls).
The On/Off indicator light signals that your dryer
is in use or ready to select a programme. If this light
flashes it indicates there is a fault (see Troubleshooting).
The ON/OFF button : If the dryer is running and
this button is pressed, the dryer stops. Press again,
the dryer restarts.
The Progress or Delay lights show you the status of
the programme, or the delay time when they flash.
During a delayed start the lights flash to show the
delay selected. When (not flashing) they show each
stage of the programme by the corresponding light
turning on (see Start and Programmes).
The PROGRAMMES knob sets the programme:
rotate it until the indicator is pointing to the programme
you want to select (see Start and Programmes).
The START/CANCEL button starts a selected
programme. When you press this button there will be
one beep and the progress lights will flash to confirm
the action. If you have not set a programme, the buzzer
will beep four times. When a programme is running,
holding this button cancels the programme and stops
the dryer (see Start and Programmes).
The OPTION buttons select available options for your
selected programme (see Start and Programmes).
The Option lights indicate that the option has been
selected by the button to the left of the appropriate
light.
The Drying Guide allows you to consult a user friendly
table of fabric types and load capacities.
The Empty Water indicator light signals that the
water container should be emptied. When it is flashing
it indicates that the container is full.
The light will take a few seconds to go out after
Control panel
Dryer Description
Empty Water
Light
Drying Guide
PROGRAMMES
Knob
START/CANCEL
Button
Indicator
Progress or Delay
Lights
OPTION
Buttons
Option
Lights
On/Off
Light
ON/OFF
Button
To open the door The features
Press and release the front
panel in position shown
Water container
Air intake
grille
Rating plate
Door catch
Filter
Door latch
Model &
Serial
numbers
Condenser cover handle
(Pull to open)
Condenser cover