Filter
Top Products
Installation
3
Drainage connections
A. Connect the drain hose, without kinking it, to a
draining duct or a wall drain fixed at a height
between 65 and 100cm from the floor.
B. Alternatively, place it over the edge of a basin,
sink or tub, fastening the hose supplied to the tap.
The free end of the hose should not be under
water.
! We advise against the use of hose extensions. In
case of absolute need, the extension must have the
same diameter as the original hose and must not
exceed 150cm in length.
Electrical connections
Before plugging the appliance into the mains socket,
make sure that:
● the socket is earthed and in compliance with the
applicable law.
● the socket is able to sustain the appliances
maximum power load indicated in the Technical
Details table (on the right).
● the supply voltage is included within the values
indicated in the Technical Details table (on the
right).
● the socket is compatible with the washing
machines plug. If this is not the case, replace the
socket or the plug.
! The washing machine should not be installed in an
outdoor environment, not even when the area is
sheltered, because it may be very dangerous to
leave it exposed to rain and thunderstorms.
! When the washing machine is installed, the mains
socket must be within easy reach and should be
connected to a suitable electrical supply.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent or
dangerously compressed.
! The power supply cable must only be replaced by
an authorised serviceman.
WARNING! The company denies all liability if and
when these norms are not respected.
The first wash cycle
Once the appliance has been installed and before
you use it for the first time, run a wash cycle without
detergent and no laundry, setting the 90˚C
programme without a pre-wash cycle.
Models A1636S, A1636, A1436 and A1235
59.5cm wide
Dimensions 85cm high
60cm deep
Capacity from 1 to 6kg
Electric voltage 220/230 Volts 50Hz
connections maximum absorbed power 1700W
Water
maximum pressure 1 MPa (10 bar)
connections minimum pressure 0.05 MPa (0.5 bar)
drum capacity 53 litres
Spin Speed up to 1600 rpm - A1636S & A1636
up to 1400 rpm - A1436
up to 1200 rpm - A1235
Control programme 3
programmes temperature 60˚C
according to run with a load of 6 kg
IEC456
directive
This appliance is compliant with the
following European Community
Directives:
- 72/23/CEE of 19/02/73
(Low Voltage) and subsequent
amendments.
- 89/336/CEE of 03/05/89
(Electromagnetic Compatibility) and
subsequent amendments.
Technical Details
A
B