Filter
Top Products
Personalisation
7
Setting the temperature
Turn the TEMPERATURE knob to set the wash temperature (see Programme table on page 6).
The temperature can be lowered, or even set to cold wash ( ).
Setting the spin speed
Turn the SPIN SPEED knob to set the spin speed for the programme selected.
The maximum spin speeds for each programme are as follows:
Programmes Maximum spin speed
Cotton 1600rpm - Model A1636 1400rpm - Model A1436 1200rpm - Model A1235
Synthetics 800rpm
Wool 600rpm
Silk no
The spin speed can be lowered, or the spin cycle can be excluded altogether by selecting symbol .
The washing machine will automatically prevent you from selecting a spin speed higher than the maximum
speed for each programme.
Functions
To enable a function:
1. press the button corresponding to the desired function, according to the table below.
2. the function is enabled when the corresponding button is illuminated.
Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the
programme set.
Function
Effect
Comments
Enabled with
programmes
All
Delay Timer
Delays the start
of the wash by up
to 9 hours.
Press the button repeatedly until the LED corresponding to the
desired delay is turned on.
The fifth time the button is pressed, the function will be disabled.
N.B.: Once you have pressed the START/RESET button, the
delay can only be decreased if you wish to modify it.
1, 2, 3, 5,
6, 7, 8.
Super Wash
Allows for an
impeccable wash,
visibly whiter
than a standard
Class A wash.
This function is incompatible with the RAPID function.
1, 2, 3, 5,
6, 7, 8.
Rapid
Cuts the duration
of the wash cycle
by 30%.
This function is incompatible with the SUPER WASH function.
All
programmes
except for 1,
2, 4, 9, 10
and Draining
Easy Iron
This option
reduces the
amount of
creasing on
fabrics, making
them easy to
iron.
When this function is set, programmes 6, 7, 8, 11 and Delicate
rinse will end with the laundry left to soak (Anti-crease) and the
Rinse cycle phase LED will flash.
- to conclude the cycle, press the START/RESET button.
- to run the draining cycle alone, set the knob to the relative
symbol and press the START/RESET button.
1, 2, 3, 4,
5, 6, 7, 8.
(Model
A1235 only)
Extra Rinse
Adds one extra
rinse cycle.
Remember - you will use more water than with a standard
cycle.