Filter
Top Products
10
CAUTION: This dryer produces combustible lint and must be exhausted to the outdoors. Every 6
months, inspect the exhaust ducting and remove any lint buildup.
IMPORTANT: Dryer must be installed in a location/environment, which the ambient
temperature remains between 40° F (4.44° C) and 130° F (54.44° C).
B. UNPACKING/SETTING UP
Remove protective shipping material (i.e., plastic wrap and/or optional shipping box) from dryer.
IMPORTANT: Dryer must be transported and handled in an upright position at ALL times.
The dryer can be moved to its final location while still attached to the skid or with the skid removed. To unskid
the dryer, locate and remove the four (4) bolts securing the base of the dryer to the wooden skid. Two (2) are
at the rear base (remove the back panel for access) and two (2) are located in the bottom of the lint chamber. To
remove the two (2) bolts located in the lint chamber area, remove the lint door.
To increase bearing life and improve efficiency, the dryer should be tilted slightly to the rear.
The lint coop is supported during shipping by a bracket. REMOVE THIS BRACKET BEFORE STARTING
THE DRYER.
If more headroom is needed when moving dryer into position, the top console (module) may be removed.
To Remove Top Console (Module)
1. Disconnect the ground wire (A) at the
rear upper left hand corner of dryer.
2. Remove the four (4) sets of nuts and
washers (B) holding the console (module)
to base.
3. Open the control door/control panel and
disconnect the white 9-pin plug connector
(C) located in the base of the control box.
4. Disconnect motor harness(es) (D)
located in rear electrical box.
5. Disconnect 2-pin connector (E) located
in rear electrical box. (On some dryers,
this is optional.)
6. Lift the console (module) off the dryer
base.