Filter
Top Products
25
5. Make a complete operational check of
ALL operating controls.
NOTE: If computer program changes are required, refer to the computer programming section of the
manual supplied with the dryer.
6. The dryer should be operated through one (1) complete cycle to ensure that no further adjustments are
necessary and that
ALL components are functioning properly.
BASKET (TUMBLER) COATING
The basket (tumbler) is treated with a protective coating. We suggest dampening old garments or cloth material
with a solution of water and nonflammable mild detergent and tumbling them in the basket (tumbler) to remove
this coating.
J. PREOPERATIONAL INSTRUCTIONS
NON-COIN MODELS
To start the dryer:
Microprocessor controller (computer) dryers:
1. Light emitting diode (L.E.D.) display will read “REAdY” (meaning no cycle in progress).
2. Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., key “E”) to start
(rotate) the dryer.
3. L.E.D. display will now show “Cycle In Progress” and “Cycle Status” meaning that the dryer is in the
drying cycle (dry mode for 30 minutes) and count downwards in minutes.
NOTE: Pressing keyboard (touch pad) key “A,” “B,” “C,” “D,” or “F” will also start the dryer. The
six (6) preprogrammed drying cycles “A” through “F” have been stored in the microprocessor
controller (computer) memory. Refer to the Programming Manual supplied with the dryer for
more specific operating instructions.
NOTE: The dryer can be stopped at any time by opening the main door or by pressing the “STOP”
red key. To restart the dryer, press the “START” green key or a preprogrammed cycle key
(i.e., “E”).
NOTE: Selection (settings) changes can be made at any time during the drying cycle by pressing the
“STOP” red key twice. The L.E.D. display will return to “REAdY” at which time a new cycle
selection can be made.