Filter
Top Products
6 American Dryer Corporation 450280-1
OVEN HOUSING COMPONENTS:
GAS VALVE/IGNITION SYSTEM COMPONENTS:
BURNER TUBE
IGNITOR
GAS VALVE
For Models M31,M50,M75
OVEN CHAMBER
RADIANT
SENSORS
HOT SURFACE
IGNITOR
Dual Burner M50,M75
RADIANT SENSOR
BURNER HIGH-LIMIT
GAS VALVE
HOT SURFACE
IGNITOR
TUMBLER SUPPORT
WHEEL ASSEMBLY REPLACEMENT:
The front wheel assemblies can be replaced with
the lower front panel removed. Remove the three
bolts by reaching upward with a socket or box
wrench. The illustration below is provided to show
the location of these wheels as the wheels cannot
easily be seen while standing in front of the dryer.
All wheel assemblies are mounted on slots to allow
for alignment of the tumbler. After one or more wheel
assemblies are replaced, the tumbler must be
realigned.
The left rear wheel assembly can be removed with
just the back guard removed. The rear right wheel
requires removing the back guard, heat duct, and
oven. Be sure to mark the position of rear wheel
brackets prior to removal (refer to photo right).
For Models M50,M75
For Models M31