Filter
Top Products
31
J. PREOPERATIONAL INSTRUCTIONS
1. To start the dryer:
a. OPL Microprocessor Controller (Computer) Dryers...
1) The light emitting diode (L.E.D.) display will read “REAdY” (meaning no cycle in progress).
2) Press the letter on the keyboard (touch pad) corresponding to the cycle desired (i.e., key “E”)...
a) The dryer will then start (rotate).
3) L.E.D. display will now show “Cycle In Progress” and “Cycle Status” meaning that the dryer is in
the drying cycle (dry mode for 30 minutes) and count downwards in minutes.
NOTE: Pressing keyboard (touch pad) key “A,” “B,” “C,” “D,” or “F” will also start the dryer. The
six (6) preprogrammed drying cycles “A” through “F” have been stored in the microprocessor
controller (computer) memory. Refer to the Programming Manual supplied with the dryer for
more specific operating instructions.
NOTE: The dryer can be stopped at any time by opening the main door or by pressing the red
key. To restart the dryer, press the green key or a preprogrammed cycle key (i.e., “E”).
NOTE: Selection (settings) changes can be made at any time during the drying cycle by pressing the
red key twice. The L.E.D. display will return to “REAdY” at which time a new cycle
selection can be made.
b. Dual Timer Dryers...
1) Turn drying timer knob for a time of 20 minutes.
2) Select drying temperature.
3) Push “Start” button.
4) To stop dryer, open the main door.
c. Coin Microprocessor Controller (Computer) Dryers...
1) When turning on power, or when no cycle is in progress, the display will read “Amount Required to
Start the Dryer.”
2) Insert coin(s).
3) Once the correct amount of coin(s) has been inserted, the display will prompt you to “Select
Temperature.”
4) Select temperature by pressing the “HI,” “PP,” or “LO” temperature selection buttons. The dryer
will start and will read the temperature selected and the time remaining.
Press and hold the
stop/clear key
4
: DEFAULT
SETTINGS
4
Next
page
Or number