Filter
Top Products
35
5. Make a complete operational check of
ALL operating controls.
NOTE: If computer program changes are required, refer to the computer programming section of the
manual supplied with the dryer.
6. The dryer should be operated through one (1) complete cycle to assure that no further adjustments are
necessary and that ALL components are functioning properly.
BASKET (TUMBLER) COATING
The basket (tumbler) is treated with a protective coating. We suggest dampening old garments or cloth material
with a solution of water and nonflammable mild detergent and tumbling them in the basket (tumbler) to remove
this coating.
7. Check the electric service phase sequence (3-phase [3ø] models only). While the dryer is operating, check
to see if the blower wheel (impellor/fan) is rotating in the proper direction. Looking from the front, the
blower wheel (impellor/fan) should spin in the clockwise (CW) direction. If it is, the phasing is correct. If
the phasing is incorrect, reverse two (2) of the three (3) leads at connections L1, L2, and L3 of the power
supply to the dryer.
IMPORTANT: If the blower wheel (impellor/fan) is rotating in the wrong direction, this will not only
drastically reduce drying efficiency, but it can also cause premature component failure.
K. PREOPERATIONAL INSTRUCTIONS
COIN MODELS
1. When turning on power, or when no cycle is in progress, the display will read “Amount Required to Start the
Dryer.”
2. Insert coin(s).
3. Once the correct amount of coin(s) has been inserted, the display will prompt you to “Select Temperature.”
4. Select temperature by pressing the “HI,” “PP,” or “LO” temperature selection buttons. The dryer will start
and will read the temperature selected and the time remaining.
IMPORTANT: To “STOP” dryer, open main door or press the red “PAUSE” button. The dryer will
stop and if the main door is not opened, the dryer will restart after approximately
30-seconds. If the main door is opened, a temperature selection button must be
pressed to restart the dryer.
5. Upon completion of drying and cooling cycles, the display will read “Anti-Wrinkle” or “donE.”
NOTE: When in the Anti-Wrinkle program, the microprocessor controller (computer) will proceed
through the Anti-Wrinkle program until the maximum active guard time has expired, or the main
door is opened, whichever comes first.