Filter
Top Products
36
SECTION VIII
TROUBLESHOOTING
IMPORTANT: YOU MUST DISCONNECT and LOCKOUT THE ELECTRIC SUPPLY
and THE GAS SUPPLY BEFORE ANY COVERS or GUARDS ARE
REMOVED FROM THE MACHINE TO ALLOW ACCESS FOR
CLEANING, ADJUSTING, INSTALLATION, or TESTING OF ANY
EQUIPMENT per OSHA (Occupational Safety and Health Administration)
STANDARDS.
The information provided will help isolate the most probable component(s) associated with the difficulty
described. The experienced technician realizes, however, that a loose connection or broken/ shorted wire may be
at fault where electrical components are concerned ... and not necessarily the suspected component itself.
Electrical parts should always be checked for failure before being returned to the factory.
The information provided should not be misconstrued as a handbook for use by an untrained person making
repairs.
IMPORTANT: When replacing blown fuses, the replacement must be of the exact rating as the fuse
being replaced.
WARNING: ALL SERVICE and TROUBLESHOOTING SHOULD BE PERFORMED BY A
QUALIFIED PROFESSIONAL OR SERVICE AGENCY.
WARNING: WHILE MAKING REPAIRS, OBSERVE ALL SAFETY PRECAUTIONS
DISPLAYED ON THE DRYER or SPECIFIED IN THIS MANUAL.
A. No L.E.D. Display ...
1. Service panel fuse blown or tripped breaker.
2. Blown control circuit fuse (3AG 1/2-Amp [Slo Blo] Fuse)..
3. Failed microprocessor controller (computer).
B. Basket (tumbler) motor does not start, microprocessor controller (computer) shows drying cycle
in progress and L.E.D. motor indicator dot is on ...
1. Microprocessor controller (computer) indicator is on ...
a. Failed motor contactor (relay).
b. Failed motor.