Filter
Top Products
16
3.
Lay the dryer door on a flat, protected surface with the inside
door assembly facing up. Remove the last screw from step 1.
Remove the 2 screws holding the handle to the door.
4.
Remove the 6 screws to release the outer door assembly
from the inner door assembly (see illustration). It is important
that you remove only the 6 indicated screws.
5.
Lift the inner door assembly off of the outer door assembly.
Unsnap the handle from the outer door assembly, move it to
the other side, and snap in. Set the outer door assembly
aside.
Reverse the hinge and hinge bracket
1.
Place the inner door, screwhead side up, on the work surface.
2.
Remove the 4 screws that hold the hinge to the door.
3.
Remove the 2 screws that hold the handle bracket to the
door.
4.
Move hinge to the other side and reattach with the 4 screws
removed in step 2.
5.
Move handle bracket to the other side and reattach with the 2
screws removed in step 3.
6.
Set the inner door assembly aside.
Reinstalling the door
1.
Check for fingerprints on the glass. Clean if necessary.
2.
Place the inner door assembly into the outer door assembly.
Align the hinge in the opening on the side. To fit correctly, the
inside door assembly edge is completely inside the outside
door assembly edge.
3.
Reassemble the inner and outer door assemblies with the
6 screws.