Filter
Top Products
43
Installation
F232058
Figure 27
8. Cylinder rotation must be clockwise in a
spin step for 35-pound, 50-pound, and
85-pound capacity models. On 135-pound
and 250-pound models, rotation should be
counterclockwise in an extract step. If
rotation is not correct, disconnect power. A
qualified electrician must reverse any two
leads between the AC drive and the main
drive motor. See Figure 27.
If the washer-extractor is served by the
Premium Wet Clean Module, continue the
control function test by following the
procedure listed below.
Power Supply
AC Drive Connections
Motor Leads
Main Drive Motor
Input Power
Block on
Washer-Extractor
RST
UVW
MV001F