Filter
Top Products
F232060
43
Section 4
Removal from Service
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Decommissioning
In the event that the machine must be
decommissioned, follow these steps:
1. Remove the chemical injection supply
system, if applicable.
a. Have a qualified electrician
disconnect power to the chemical
injection supply system at
its source.
b. Using the manufacturer’s
instructions, carefully remove the
chemical injection supply system from
the machine. Make certain that no
chemical supplies come into contact
with skin or clothing.
2. Clean interior of machine, both
basket and shell.
a. Flush supply dispenser (soap dish)
with water.
b. Run a short rinse cycle to clean
detergent and chemical residues from
the interior of the machine.
3. Disconnect electrical power.
a. Shut off main power supply at the
breaker box or main control panel.
b. Do not attempt to disconnect power
supply wires from power supply. Have
a qualified electrician disconnect power
to machine at its source.
4. Disconnect hoses.
a. Disconnect drain hose from sump,
gutter, or drain.
b. Turn off water supply. Disconnect
individual hot and cold water inlet
hoses from the machine.
c. Allow time for residual water in the
machine to drain. Then disconnect
drain hose from the machine.
5. Disconnect steam hose, if applicable.
a. Turn off steam supply and allow
time for the valve to cool.
b. Disconnect steam hose
from machine.
6. Remove the machine from its
foundation pad.
a. Keep all panels in place to
provide stability when moving
the machine.
b. Verify that door is closed
and secure.
c. Loosen and remove anchor bolts
holding machine base to floor, if
applicable.
d. Break the grout seal at each corner of
the machine, using a crowbar.