Filter
Top Products
Maintenance
34
F232060© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Daily (Continued)
End of Day
1. Clean the AC drive box filter:
a. Snap off the external plastic cover
which contains the filter.
b. Remove the foam filter from the cover.
c. Wash the filter with warm water and
allow to air dry. Filter can be
vacuumed clean.
2. Clean the door gasket of residual detergent
and all foreign matter.
3. Clean automatic supply dispenser and lid
inside and out with mild detergent. Rinse
with clean water.
4. Clean the washer’s top, front, and side
panels with mild detergent. Rinse with
clean water.
5. Leave loading door open at the end
of each day to allow moisture
to evaporate.
Note: Unload the machine promptly
after each completed cycle to prevent
moisture buildup. Leave loading door open
at the end of each completed cycle to allow
moisture to evaporate.
Weekly
1. Check the machine for leaks.
a. Start an unloaded cycle to fill
the machine.
b. Verify that door and door gasket
do not leak.
c. Verify that the drain valve is operating.
If water does not leak out during the
prewash segment, drain valve is closed
and functioning properly.
Monthly
Note: Disconnect power to the machine
at its source before performing the monthly
maintenance procedures.
1. Clean the AC drive fins:
a. Remove the AC drive box cover.
b. Blow the fins clean using compressed
air at a pressure of 60 – 90 psi or by
using canned compressed air. Use care
to avoid damaging cooling fan or
other components.
Note: No amount of visible foreign matter
should be allowed to accumulate on the
fins or the finger guard.
2. Use the following procedures to
determine if the V-belt requires
replacement or adjustment. Call a
qualified service technician in either case.
a. Check V-belt for uneven wear and
frayed edges.
b. After disconnecting power to the
machine and removing all panels
necessary for access to the drive belt,
use the following method to verify
that the V-belt is properly tensioned.