Filter
Top Products
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Installation/Operation Supplement
9002062
12
Mounting Bolt Installation
(If Required)
Figure 3
After the concrete has cured and the anchors are
installed, proceed as follows:
1. Place the washer-extractor adjacent to the
foundation. Do not attempt to move it by pushing
on the sides. Always insert a pry bar or other
device under the bottom of the frame of the
washer-extractor to move it.
2. Place the washer-extractor carefully over the
anchors.
3. Put bolts through the machine in the anchors and
fasten them. The diameter of the bolt must be
minimum 1/2-13 or 12 mm.To level machine, fill
the spaces between the machine base and floor
with machinery grout. Grout completely under
all frame members. Remove front and rear panels
to gain access to all frame members. Force grout
under the machine base until all voids are filled.
4. Remove the spacers carefully, allowing the
machine to settle into the wet grout.
5. Position washers and locknuts on machinery
anchor bolts and fingertighten to machine base.
6. After the grout is completely dry, tighten the
locknuts by even increments – one after the
other – until all are tightened evenly and the
machine is fastened securely to the floor.
CFS485N
1 Base Frame
2 Bolt
3 Washer
4 Anchor Bolt/Plug
CFS485N
152 mm
(6 in.)
1
2
4
3