Filter
Top Products
Programming
24
F232061
Cycle Programming
(Continued)
When modifying a cycle, a time must be
entered for each segment. To skip a segment
or spin, set the time to “00” and press the Start
key. The following table gives the time
parameters for each segment and spin, as well
as the allowable temperature range.
Note:
Spin times in cycle segments 1–7
(Prewash–Fill 5) are entered in seconds
(30 to 240), and time for final spin in
segment 8 is entered in minutes (1 to 10).
1. Press the Up key until the computer
display shows the segment to be edited.
Press the Start key.
2. Use the Up or Down key to select the
desired segment time. Set this value to
zero to skip the segment. Press the
Start key.
3. Use the Up or Down key to select the
desired fill temperature. See the following
table for fill options.
4. Press the Start key.
5. Use the Up or Down key to select the
desired fill level. See the table below.
6. Press the Start key.
7. Use the Up or Down key to select the
desired supply option. See the table below.
Note:
If as supply 2 (SUP2) step is
programmed, the display will flash “bLCH”
(add bleach) while supply 2 is on when the
cycle is in operation.
Time and Temperature Parameters
Function Minimum Maximum
Prewash 2 minutes 30 minutes
Wash 2 minutes 20 minutes
Fill 1 2 minutes 15 minutes
Fill 2 2 minutes 15 minutes
Fill 3 2 minutes 15 minutes
Fill 4 2 minutes 15 minutes
Fill 5 2 minutes 15 minutes
Fill 6 2 minutes 15 minutes
Intermediate Spin 30 seconds 240 seconds
Final Spin 1 minute 10 minutes
Temperature 75°F (25°C) 200°F (93°C)
Fill Temperature Options
Display Fill Type
CFIL Cold fill
HFIL Hot fill
bFIL Warm fill
AFIL Auxiliary fill*
*Controls filling via an extra fill valve for special
applications only. Do not program this option unless
machine is equipped with extra fill valve.
Water Level Options
Display Fill Level
LO Low Level
n
ed
Medium Level
HI High Level