Filter
Top Products
Operation
9
F232137
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Display Indications
Table 1 through Table 5 list the various displays and
what they mean. The operator should become familiar
with these computer displays.
Display Indications for S-Series – Non-Coin
Display Meaning Display Meaning
S-05 Program identification code (ROM)
(this is an example only)
bFIL Warm fill (both hot and cold)
HoLd Wait...power has just been turned on HFIL Hot fill
CY Cycle (followed by two-digit number) LOLE Low water level
CHEC/CYC* Test cycle selected HILE High water level
FAr Degrees Fahrenheit SUP1 Supply 1
CEL Degrees Celsius SUP2 Supply 2
PrE Prewash segment (1st of 8 segments) SUP3 Supply 3
UASH Wash segment (2nd of 8 segments) SUP4 Supply 4
FIL1 First rinse (3rd of 8 segments) SUP5 Supply 5 (supply 1 and 2)
FIL2 Second rinse (4th of 8 segments) SUP6 Supply 6 (supply 2 and 3)
FIL3 Third rinse (5th of 8 segments) SUP7 Supply 7 (supply 3 and 4)
FIL4 Fourth rinse (6th of 8 segments) STOP Stop routine
FIL5 Fifth rinse (7th of 8 segments) SdLY Spin coast delay
FIL6 Sixth rinse (8th of 8 segments) dOnE Cycle and stop routine have ended
CFIL Cold fill dOOr Door not properly closed
SPIn/tI
nE*
Reads “SPIn” for one second, then
“tI
nE” followed by time for spin
FILL/STOP* Programmed water level not reached after 30
minutes
tSFL Temperature sensor failure or
temperature out of range
FULL The computer detects low water level or
higher when none should be present
* Display indications separated by a slash (/) represent an alternating display.
Table 1