Filter
Top Products
Problem
1)
Possible cause Remedy
The loading door is opened. Close the loading door.
The On/Off button was not
pushed.
Push the On/Off button.
The Start/Pause button was not
pushed.
Push the Start/Pause button.
The appliance is in the standby
mode.
Push the On/Off button.
Unsatisfac-
tory drying
results.
Incorrect programme selection.
Do the selection of the applica-
ble programme.
2)
The filter is clogged.
Clean the filter.
3)
The Dry Plus function was in
minimum mode.
Change the Dry Plus function
to the moderate or maximum
mode.
The condenser is clogged.
Clean the condenser.
3)
Too high volume of the load.
Obey the maximum load vol-
ume.
The airflow grill is clogged.
Clean the airflow grill in the
bottom of the appliance.
Dirt on the inner surface of the
drum.
Clean the inner surface of the
drum.
Too high water hardness.
Set applicable water hard-
ness
4)
.
The door
does not
close.
The filter not locked in the po-
sition.
Put the filter in the correct posi-
tion.
The laundry is locked between
the door and the seal.
Put the load correctly in the
drum.
Err (Error)
on the dis-
play.
You try to change the pro-
gramme or the function after
the start of the cycle.
Turn the tumble dryer off and
on. Make the new selection.
The function you try to activate
is not applicable with the selec-
ted programme.
Turn the tumble dryer off and
on. Make the new selection.
No drum
light
5)
Defective drum light.
Contact the service centre to
replace the drum light.
Abnormally
elapsing
time on the
display.
)
The time to end is calculated
on the basis of the volume and
dampness of the laundry.
The automatic procedure —
this is not the appliance mal-
function.
Programme
inactive.
The water container is full.
Drain the water container
3)
,
push the Start/Pause button.
18
www.aeg.com