AEG 74335 Washer User Manual


 
Operating Instructions
32
The door cannot be
opened when the ap-
pliance is switched on.
The door is locked due to a
high water level or a high
temperature. (The DOOR dis-
play is off).
Wait until the green DOOR
display lights up.
Should it still be necessary to
open the door:
turn the programme selector
to OFF turn the programme
selector to PUMP OUT. Press
START/PAUSE button.
After the water has been
pumped out, the door can be
opened.
Power failure! (All displays
have gone off.)
For safety reasons the door
remains locked for 4 to 5
minutes.
If water can be seen through
the window in the door, first
carry out emergency empty-
ing (see section “Carrying out
Emergency Emptying Opera-
tion").
After approx. 4 to 5 minutes
the door can be opened
again by pulling the handle.
Remnants of detergent
are building up in the
detergent dispenser
drawer.
Water tap is not fully open. Open the water tap fully.
Filter in the screw connec-
tion of the inlet hose at the
water valve or on the appli-
ance is blocked.
Turn off the water tap. Close
the water tap. Unscrew the
inlet hose from the water tap
and from the appliance.
Clean the filter.
The rinsing water is
cloudy.
The cause is probably a de-
tergent with a high silicate
content.
No negative effect on the
rinse results; use a liquid de-
tergent if necessary.
When pressing a pro-
gramme option button
the corresponding dis-
play does not light up.
The selected programme op-
tion cannot be combined
with the set programme.
Make another selection.
Problem Possible Cause Solution