Filter
Top Products
Something not working?
30
If you do not find the required information in this manual to remedy a
disturbance, please call the customer service.
Replace the interior light
0 A replacement bulb can be purchased through your local AEG Service
Force Centre (Part No: 647072580).
1
Warning! Never use standard light bulbs in your Lavatherm.
0 Isolate the appliance from the mains supply.
0 Screw-off the bulb cover. (The bulb is located at the top behind the
door; see Front view).
0 Replace the defective bulb.
0 Screw-on the bulb cover.
1
Warning! For safety reasons the bulb cover must be screwed-on. The
dryer must not be operated, without the cover in place.
The dryer terminates the
drying process automatically:
END is displayed shortly after
program start; no display of
the extent of drying
Too dry or too little
laundry filled-in for the
selected program
Select time program or
higher drying stage (e.g.
EXTRA DRY instead of
CUPBOARD DRY)
The drying process takes
unusually long. 4.5 hours
after the beginning of the
drying process:
- END display flashes
- acoustic signal sounds
- discontinuation of the
drying process
- error code C6 is displayed
SPECIAL CARE button
pressed and too much
laundry filled-in
Check the program
selection: SPECIAL CARE
button appropriate only
for laundry amounts up
to 2.5kg
Too much laundry
filled-in
Reduce the amount of
laundry filled-in
Laundry too damp
Pre-dry the laundry more
thoroughly
Symptom Possible cause Solution