Filter
Top Products
Something not working?
28
If you do not find the required information in this manual to remedy a
disturbance, please call the customer service.
The door cannot be closed
Fluff filter has not been
inserted correctly and/or
the filter lid not closed
Replace the fluff filter
and ensure the filter lid is
closed
The drum illumination does
not work
The program selector is in
the OFF (UIT) position
Turn the program selector
dial to LIGHT
(VERLICHTING)
The bulb needs replacing Replace bulb
Display EMPTY WATER/CLEAN
FILTER (RESERVOIR/ZEEF) is lit
Condensate container full
Empty the condensate
container
Fluff filter is clogged Clean the fluff filter
EMPTY WATER/CLEAN FILTER
(RESERVOIR/ZEEF) indicator
illuminated, even though the
container has already been
emptied and the filter has
been cleaned
Foreign bodies, e. g. ani-
mal hairs, can block the
inlet nozzle as well as the
valve on the end of the
container
With the container pulled
out, switch on the
appliance momentarily.
The blockage can be
removed from the contai-
ner shaft or the hair clea-
ned out of the valve
The dryer terminates the
drying process automatically:
END (EINDE) is displayed
shortly after program start
Too dry or too little
laundry filled-in for the
selected program
Select time program or
higher drying stage (e.g.
EXTRA DRY (EXTRA-
DROOG) instead of
VERY DRY (INTENSIEF-
DROOG))
The drying process takes
unusually long. 4.5 hours
after the beginning of the
drying process:
- END (EINDE) display is illu-
minated
- acoustic signal sounds
- discontinuation of the
drying process
-
Program run display is flash-
ing
SPECIAL CARE (LAGE
TEMPERATUUR) button
pressed and too much
laundry filled-in
Check the program
selection: SPECIAL CARE
(LAGE TEMPERATUUR)
button appropriate only
for laundry amounts up
to 2.5kg
Too much laundry
filled-in
Reduce the amount of
laundry filled-in
Laundry too damp
Pre-dry the laundry more
thoroughly
Symptom Possible cause Solution