AEG 40820 Washer User Manual


 
User’s instructions
30
10.3.5. Water inlet
Please install the water inlet hose onto the back of your washing
machine :
- Insert the seal in the hole at the bottom of the
back panel (fig. 1).
- Screw on the bottom fitting of the water inlet
hose as shown in fig. 2 and fig. 3.
- Connect the feed hose connector onto the water
inlet tap, taking care to position the gasket
correctly.
- Turn on the water inlet tap.
The water inlet hose cannot be extended. If it is
too short, please contact the After Sales
Department.
10.3.6. Drain
- Assemble the hose holder onto the drain hose.
- Place the assembly in a drainage pipe (or in a
sink) at a height between 70 and 100 cm. Make
sure that it will not fall out.
You must provide an air intake at the end of the drainage hose, to
avoid any water being siphoned.
Important: the drainage hose must not be extended, on any account.
If it is too short, contact a qualified engineer.
10.3.7. Electrical connection
You can only connect this washing machine to 230 V single phase
power supply.
Check rating of the fuse line: 10 A at 230V.
The washing machine must not be connected through an extension
cable or a power bar. Check that the earthing connection is conform
with the regulations in force.