Filter
Top Products
Installation
Unpacking
All transit bolts and packing must be removed before using the appli-
ance.
Using a spanner, unscrew and remove the rear
right-hand bolt and lay the machine on its
back, taking care not to squash the hoses. This
can be avoided by placing one of the corner
packing pieces between the machine and the
floor.
Remove the poly-
styrene block from
the bottom of the
machine and
release the two
plastic bags.
Carefully remove the
right-hand bag (1)
then the left-hand
bag (2) by pulling them towards the centre of the machine.
Set the machine upright and remove the two remaining bolts from
the back.
Pull out the three
plastic spacers from
the holes into which
the bolts were fitted.
Plug the open holes
with the plugs which
you will find in the
plastic bag containing
the instruction booklet.
You are advised to keep all transit devices so that they can be refitted if the
machine ever has to be transported again.
95
2
1
132994110gb.qxd 11-04-2002 16:06 Pagina 95