A SERVICE OF

logo

Open as PDF
next previous
7
About the Remote C
ontrol
•
The area between the remote control and the main
unit must be clear of large obstacles.
•
Do
not expose the remote control sensor to strong
lighting, especially an in
vert
er type fluorescent
lamp
as t
his
may cause the remote co
ntrol
to
not
function properly.
Installing Batteries in the
Remote Control
1. Turn the remote co
ntrol over and slide the battery
compartment
cov
er
off towards the direction of the
arrow.
2. Ins
ert th
e AA batteries, positioning them according
to the polarity
(+, --) markings on the
to the polarity (+, --) markings on theto the polarity
inside of the
batter
y compart
ment.
3. Close the battery compart
ment cover.
Image shown is a generic model for reference.
Battery Replace
ment
If you fi nd that the dis
tance between the remote
control
and the main unit must be shorter in o
rder to
use the remote control
, this means that the batteries
are low and must be changed. Replace both
batteries with ne
w ones.
Battery N
otes:
•
Use AA
batteries.
•
Be sure the polarities (+,
-
) are
correct. (
See t
he
illustration inside the battery compartment).
•
Remove the batteries when not using the remote
control for an extended period of time.
•
If batteries l
eak, dispose of them immediately.
Avoid
skin, clothing and an
y other conta
ct with the
leaked material.
Clean the battery compartment
thoroughly before installing new
batteries.
•
Do not mix old and new batteries.
•
Do not mix alkaline, standard (carbon-zinc) with
rechargeable (nickel-cadmium) batteries.
Connecting the
Power Cable
Plug the supplied AC power cable into the AC inlet
after all other connections are complete and then
plug the AC power cable to an AC wall outlet.
CAUTION
Use the supplied AC cable. Do not use other AC
power cables as doing so may result in fi re hazard or
electrical shock.
Image shown is a generic model for reference.
Getting Connected