A SERVICE OF

logo

3. Make sure the voltage selection switch (directly above the power cable connector
on the rear of the system unit) is set to the voltage appropriate for the voltage
available in your area.
4. Make sure all externally attached devices are turned off.
5. Connect the system unit power cord to the power connector on the system unit.
Secure the connection then plug the display power cord and the system unit
power cord into properly grounded electrical outlets.
ATTENTION: As soon as the system unit power cord is plugged into the system unit
and power outlet, the power is on within the system unit
whether or not the system
unit is turned on.
Do not plug in the system unit power cord if the cover of the
system unit is removed.
1-14
7043 43P Series User's Guide