Configuring, Modifying, and Monitoring the Unit
23
IP Commands
This section lists the IP Configuration commands available at the CLI. It is separated into the
following command sections:
• IP configuration
• Address Resolution Protocol (ARP)
• Bootp
• Ping
To view the IP commands, enter IP at the CLI prompt. The following are the available
IP commands.
IP Configuration
get-ip
The get-ip command shows the device’s current IP address, if any. The following are
examples with no IP configuration and an IP configuration defined.
• No IP Configuration defined:
SYS_console> get-ip
The device has no IP Address defined
SYS_console>
• IP Configuration defined:
SYS_console> get-ip
The device IP address is: 194.090.136.187
SYS_console>
get-ip-cfg
The get-ip-cfg command shows the complete current IP configuration, that is, the address,
network mask and broadcast address. The following are examples with no IP configuration and
an IP configuration defined.
• No address defined:
SYS_console> get-ip-cfg
The device has no IP Address defined
SYS_console>
• IP Configuration defined:
SYS_console> get-ip-cfg
The device IP address, netmask and broadcast are:
IP address : 194.090.136.187
IP netmask : 255.255.255.000
IP broadcast : 255.255.255.255
