Overview
3
Feature Summary
The following are the Performance/Configuration and Management features supported on the
NH2025-10 switch.
Performance/Configuration
• 24 switched 10/100Mbps ports and a dport to accommodate one of the following uplink modules:
− Single Gigabit Ethernet port (MM,SM)
− Dual Gigabit Ethernet ports (MM,SM)*
− 8 10/100 auto-negotiation ports module
− 2 100Base-FX ports (MM,SM)
• The highest common port speed is automatically set when connecting any standard
compliant (802.3u Auto-negotiation) network device or station.
• Each 10/100Base port operates in half duplex mode, for shared networks, or in a dedicated
full duplex link, running at up to 200Mbps.
• All ports support auto-polarity detection and correction.
• Store-and-Forward switching.
• Flow Control (IEEE 802.3x) provides effective packet loss protection under heavy load
conditions, minimizing delays and retransmission of data, thus improving network performance.
• Supports the creation of up to 64 Virtual LANs.
• Supports the Inter-Switch VLAN tagging standard which enables the creation of multiple
groups across the network (IEEE 802.1q).
• MAC address table (up to 12K unicast entries).
• Maximum wire speed throughput on all ports simultaneously.
• Supports RMON (groups 1,2,3,9), Telnet for rapid fault detection and isolation.
• Port Mirroring.
• Spanning Tree Algorithm prevents broadcast loops
Management
• Fully managed through the comprehensive NBase-Xyplex MegaVision Network Management
System, or any SNMP-based management platform.
• Extensive Command Line Interface (CLI) management provides out-of-band administration.
• Supports NBase-Xyplex's private MIB, Ethernet MIB and bridge MIB. The status of each
port is displayed by an LED on the front panel. This LED indicates active and link status.
