Making Connections to the Remote
At the back of the remote are four connectors, as shown above. Only the EVE/NET connector is
required to be connected, the use of rest is optional.
Ü See Appendix A for pin out information for these connectors.
EVE/NET
This requires an 8 pin RJ45 for connection to the EVE/NET network. Power for the remote is
also supplied by this connection. For a simple system, all that is required is to use the supplied
cable to connect between this connector and the similar one on the back of the Orville.
Ü See Appendix B for further installation and EVE/NET connection information
Joy Stick
This is a 15 pin female D-type connector wired as a standard PC game port connector. It will
support a standard PC type joystick (or two joysticks with a suitable adaptor) .
Ü See Using a Joystick on page 10.
MIDI in
This is a 5 pin DIN type connector that can be used as MIDI in, or combined MIDI in and
MIDI out.
Ü See Using MIDI with the remote on page 11.
MIDI out
This is a 5 pin DIN type connector that can be used as MIDI out. There is no MIDI thru’
connector.
Ü See Using MIDI with the remote on page 11.
EVE/NET Remote User Manual
Document 141044
Release 1.0 Page 7 of 20
out
in
Stick
