USER key
This is a general purpose key that can be used as a source for a controller.
Ü Extra controller options with EVE/NET on page 3.
Encoder Knobs
These are general purpose controllers, comprising a knob, an LED indicator ring around it to
show the knob position, and a switch which is operated by pushing down on the knob.
The knobs are used to control the on-screen parameters, as shown below (knobs numbered
from left to right):
knob 1à çknob 5
knob 2à çknob 6
knob 3à çknob 7
knob 4à çknob 8
Ÿ The encoder knobs always control the parameters on the displayed screen - they do not need to be
assigned before use.
Ÿ When you turn a knob, the cursor will move to the parameter that is being changed. This can be
distracting if you try to change more than one at a time.
Ÿ Once the cursor has moved to a parameter, this parameter is now selected, and can be changed by
means of the main wheel or, where appropriate, the numeric keypad.
Ÿ Each click on the knob corresponds to the resolution of the parameter, i.e., the amount the
parameter will change for one press of the up/down arrows on the right of the numeric keypad.
For some parameters, this may be too fine - use the main knob instead.
Ü See the Programming Manual to see how to change the resolution of a parameter in a preset. System parameters
cannot be changed.
Ÿ The indicator ring shows the current setting of the knob, with the bottom left indicator being the
minimum possible value, and the bottom right being the maximum value. Since there may be more
‘clicks’ over the entire control range that there are indicator lights, the indicator will not always
change for each click of the knob.
Ÿ If there is no on-screen parameter corresponding to a given knob, or it is not variable, the
indicator ring for that knob will be off.
EVE/NET Remote User Manual
Document 141044
Release 1.0 Page 9 of 20
