1. Manuals
  2. Laundry Appliance Support
  3. LG Electronics Support
  4. Washer Support
Support User Manuals
Question About LG Electronics Washer None
OE displayed on front...

after wash and rinse the machine stops and display oe. Please let me know the fix.

Asked by Kurt on 01/20/2009 2  Answers

ManualsOnline posted an answer 15 years, 10 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

Deana posted an answer 15 years, 10 months ago

5 I have the same problem. I did solve it temporaily by unplugging the machine for ten minutes and then re-start but that has come to an end after three incidents. I really don't want to pay $80.00 for someone to clear the code. HELP! Please.
Was this answer helpful?

Paul posted an answer 15 years, 10 months ago

5 I just had this problem and fixed it myself on a WM2077HW washer (very similar). If it's not a clogged drain filter, then I followed these instructions found at the site below. I had a wooden toothpick jamming the impeller. It is very easy to take motor off/apart. I did not even have to remove the hoses. Follow these instructions: You will need to replace or possibly fix the drain pump motor. The pump impeller may have separated from the motor shaft. You can push it back on, but it will just come off again. I have not tried adding adhesive because I didn't want a call back. That may work if you want to try it. To replace pump motor: Unplug electrical cord. Take the rectangular recess out by using a putty knife on the left or right side, Remove 3 phillips screws mounting pump. Pull machine forward about two feet to allow you to tilt the machine back to lean it against the wall. Reach under to access the pump. It is held in place by a plastic tab you can depress to remove, but if you break the tab, don't worry, as the mounting screws will hold your pump in place just fine when reinstalled. Remove pump by disconnecting hoses and electrical plug - or change out pump motor (three phillips head screws hold it in place). Remember to mark where the black and brown wires go too. One other hint, make a little mark on the housing where the 3 screws go into, so when you fit the motor back on, you know exactly how it fits back together. Sounds kind of complicated, but was actually very easy job. Good luck
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual