1. Manuals
  2. Laundry Appliance Support
  3. Hotpoint Support
  4. Washer Support
Support User Manuals
Question About Hotpoint Washer None
washer tub rusted thru...

I have a 5 year old washer and it has rusted thru under the agitater to the point of disconection from the motor. where can I get a replacement?

Asked by troy on 12/10/2008 2  Answers

ManualsOnline posted an answer 15 years, 10 months ago

The ManualsOnline team has found the manual for this product! We hope it helps solve your problem. Get the Manual Here

troy posted an answer 15 years, 10 months ago

5 Hub is part number wh45x10027 and cost is $30.99 You will end up needing the hub nut too Part number wh2x1193 $5.99 research this using these parts numbers as they are the manufacturers numbers.
Was this answer helpful?

troy posted an answer 15 years, 10 months ago

5 Remove the front panel with a pry between the top and front panel to release the clips on the top of the front panel. remove the screws holding the top on . lift and pull the top to release it from the rear clips. release the clip on the door harness. remove the water inlet solodoid bracing and the control panel. release the tub cap clips and lift the tub out. The nut holding the hub to the trans is a left handed nut and is on very tight. It is aluminum , so will sheer easilt with a sharp chisle and hammer blow in the lock wise dirrection. relace everything and be sure the fill level tube is secured before the front panel is replaced. all in all about a 3 in ease of doing it...and an hour of time once you have the replacement parts.
Was this answer helpful?

Add Your Answer

Please Note: Do not submit personal information as it will be displayed online.
Ask a Question Request a Manual